Part of a series on installing the hotend.
Just Do It
Not much to say here about this step. It's really up to you to fit everything into place. Somethings might be tight, so disassemble as much as you need. Reassemble. Push things around. Everything will fit just fine.
 |
| Fits like a glove. |
|
|
If things aren't fitting correctly go back to the drawing board. Work with what you have. Everything worked fine for me but your mileage may vary.
Just Done It
Now that your hotend is in place, and looking mighty fine I might add, time to get down and dirty with
flashing the firmware on your Printrboard.
No comments:
Post a Comment